winmau blade 5 screws
hi,all i got a problem with the 'adjusting screws' of my blade 5 !
when i screw them the board is tight against the wall !
but after a few training sessions the 'screws ' come loose again and also the whole board !
does anyone know to 'fix' this problem !

cheers,mark. Huh
YOU MUST CRAWL BEFORE YOU CAN WALK ! Moddarts
Reply
Are you using a standard 'U' shaped wall bracket?  If so, make sure that's not loosening.  Or the centre post is not 'climbing' the bracket, which has happened to me.  Best to take the board right off when rotating with this type of wall bracket.  And only tighten the 'Roto-locks' the bare minimum needed to level the board.  Or they will pull on the bracket.

cheers...
Reply


Possibly Related Threads...
Thread Author Replies Views Last Post
  winmau blade 5 best choice !? nightcrawler 6 594 10-22-2018, 08:54 PM
Last Post: ChrisTheFish
  nodor supamatch 2 / winmau blade 5. nightcrawler 7 803 09-30-2018, 07:19 PM
Last Post: Crusher17
  gladiator gen 3. / winmau blade 4. nightcrawler 9 694 09-28-2018, 03:42 PM
Last Post: nixer55
  Gladiator 3 vs blade 5/blade 5 dc Jared Thomas Webster 19 5,396 07-31-2018, 01:21 PM
Last Post: Chappers
  Winmau Blade 4 DC rock solid bottom half Nurio 26 3,822 08-12-2016, 11:58 AM
Last Post: tomsmith



Users browsing this thread: 1 Guest(s)