2BA tap size?
(11-30-2015, 07:28 PM)Chardotz Wrote: Lol. I know it's 2ba. Is there a tap size that is the same in America or metric numbers.
 No BA thread & pitch is different to either imperial or metric.
Reply
(12-30-2015, 03:57 PM)Lathe Guy Wrote: You know not all threads are the same length. If the barrel is not drilled deep enough then the threads aren't deep enough. I have found this out a lot. If you need help let me know. Thanks Matt

what are the specs on the 10/32tap(H3?,bottoming?) and the drill bit size you use to turn a steel tip into a soft tip? I have a lathe I play around on. thanks
Reply
(11-30-2015, 07:28 PM)Chardotz Wrote: Lol. I know it's 2ba. Is there a tap size that is the same in America or metric numbers.

Nope 2Ba is 2Ba you need a set of 3 1st/taper & plug if all else fails Ebay have sets for sale
Reply




Users browsing this thread: 1 Guest(s)